3D-effect on ShowEditor for CS-1000-RGB3D
- parnaud
- Topic Author
- Offline
- New Member
Less
More
- Posts: 5
- Thank you received: 0
8 years 4 months ago #88
by parnaud
3D-effect on ShowEditor for CS-1000-RGB3D was created by parnaud
Good morning,
ShowEditor is performing very well on my CS-1000 RGB 3D but everything is coming in 2D.
How can I define some figures in 3D?
Best regards
Philippe Arnaud
ShowEditor is performing very well on my CS-1000 RGB 3D but everything is coming in 2D.
How can I define some figures in 3D?
Best regards
Philippe Arnaud
Please Log in or Create an account to join the conversation.
- admin
- Offline
- Administrator
Less
More
- Posts: 250
- Thank you received: 21
8 years 3 months ago #91
by admin
Replied by admin on topic 3D-effect on ShowEditor for CS-1000-RGB3D
The built-in 3D effects of the Laserworld CS-1000RGB 3D are triggered over DMX - like the ones in the Proline Series. Laserworld Showeditor has a powerful DMX control window that allows for creating DMX control effects linked to ILDA laser figures. To do this, you need the
Laserworld DMX Adapter
for getting the DMX signal out of the ILDA line.
Then please follow the steps decribed in the manual here:
www.laserworld.com/shop/dmx-adapter
The basic DMX feature should do for the effects switch, you normally do not need to configure an intelligent fixture for it.
The hint how to link a DMX macro to an ILDA figure: Assign the DMX macro to the same key as the ILDA figure you want it to go together with.
Then please follow the steps decribed in the manual here:
www.laserworld.com/shop/dmx-adapter
The basic DMX feature should do for the effects switch, you normally do not need to configure an intelligent fixture for it.
The hint how to link a DMX macro to an ILDA figure: Assign the DMX macro to the same key as the ILDA figure you want it to go together with.
Please Log in or Create an account to join the conversation.