Taking pictures of laserprofile

Hey folks,
I would like to take a picture of the laserprofile. Could you please advise how to handle my questions:
How can I switch the laser in continious operation. The mirror modul is not attached at the Laser but at the Minilumax.
Any ideas how to take a good picture? (Distance, exposure,..)

Just take the LumaxTest Tool. It allows you to operate the outputs by card.
Try to turn on the colour channels until the lasers are projecting a little point onto the wall.

Measure the laser point (use scale paper). The longer the distance between the wall the better visible is the point. Try it with a distance of 10 m.

Send me a picture of your result